Lagunamotoclub.com

MOTO CLUB モトクラブ
Рейтинг статьи
1 звезда2 звезды3 звезды4 звезды5 звезд

How to remove the bumper from a Audi R8 ?

あなたが少し日曜大工の場合、あなたはかなりの可能性があります eager to handle most of the work to be achieved on your Audi R8, but some are more difficult than others and require the removal of body parts or elements to access the component you want to work on. We really want to help you in this operation. That’s why in this article we are going to see how to remove the bumper from a Audi R8. This procedure is not very difficult and you should be able to do it with few tools. To do so , first we will discover how to remove the front bumper of your Audi R8, then how to remove the rear bumper of this one.

How to remove the front bumper from a Audi R8

So let’s start our document with the front bumper of your Audi R8. To take it off, you will just need a set of ratchet wrenches, some screwdrivers and torx bits. Here are the guidelines you will have to stick to in order to disassemble the bumper of your Audi R8 in good conditions:

  • If you want to be more relaxed, we advise you to put your Audi R8 on stands and to remove the front wheels to have a good access to the whole front bumper.
  • 車のボンネットを開けて: 当たり前のようですが、エンジン コンパートメントのバンパー アタッチメントにアクセスする必要があります。
  • ホイール アーチを取り外します。フェンダーとも呼ばれますが、 邪魔になり、すべてのネジにアクセスできなくなります on the front bumper of your Audi R8. Dependant on your automobile features and the year of your model, you will also have the ability to find staples, to accomplish this, you will just have to use a staple extractor or to do it carefully with a big flat screwdriver, and use a lever to open the staple.
  • Then you will have to unscrew the screws that is behind your mudguard and that fastens the front bumper of your Audi R8 on the sides.
  • エンジンルームのバンパー上部のネジを緩めるか、クリップを取り外します。
  • Now it’s time to go under your Audi R8 to unscrew the bolts that are on the chassis of the automobile, you will find some バンパーの中央と側面にあります。
  • ことを確認してください プレート照明と距離制御センサーの接続を外します あなたがそれを持っているなら。
  • 慎重に フロントバンパーを外す 最初に側面のクリップを外します。 外れない場合は、ほぼ確実にネジまたはクリップを忘れています。 地面に触れて傷がつくのを防ぐために、カーペットなどを使用することを考えてください。
Weiterlesen:
Key stuck in ignition of Audi R8, what to do ?

それだけです。すべての手順を見てきました。 how to remove the front bumper from your Audi R8、それを再組み立てするには、反対の方法でステップに固執します。

How to remove the rear bumper from a Audi R8

And now, regardless if the process is quite similar, we will look at the case of removing the rear bumper from your Audi R8. For each stage to avoid repeating ourselves we will just give you the broad highlights, read the part 1 if you have any concerns or questions for more details.

  • Start with undertaking the same first stage, that is, lift your Audi R8 and remove your rear wheels in order to have an optimal working space to remove the bumper of your Audi R8 serenely
  • Remove the rear wheel arches of your Audi R8 to access the side bumper side brackets
  • トランクを開けて
  • Remove the side brackets in your wheel arches to make it much easier to remove the bumper from your Audi R8.
  • Take away the lower bindings below your Audi R8.
  • While doing so, remember to un plug the rear license plate light and the reverse radar sensors if you are equipped with them.
  • トランクの上部から上部ブラケットを緩めます。
  • 今あなたがしなければならないすべては remove the rear bumper from your Audi R8, stick to the same operation as for the front bumper

ここでは、これらの XNUMX つの部分を通じて発見した、 how to remove the bumper from a Audi R8 whether it is the front one or the rear one the techniques are almost the same and it is enough to be meticulous to make everything go well.

Audi R8 のチュートリアルをもっと見たい場合は、Audi R8 カテゴリにアクセスしてください。

голоса
Рейтинг статьи
Weiterlesen:
ブレーキ ライト Audi R8 が点灯したままです。どうすればよいですか?
Ссылка на основную публикацию
Adblock
detector